Installation - Veratron OCEANLINK 4.3 Benutzerhandbuch

INSTALLATION

Before starting work, disconnect the negative terminal of the battery to avoid the risk of a short circuit. If the vehicle is
equipped with additional batteries, the negative terminal of all batteries must also be disconnected if necessary. Short
circuits can burn cables, explode batteries and cause damage to other electronic systems. Remember that by
disconnecting the battery, all data entered in the temporary electronic memory will be lost and will have to be
reprogrammed.
BEFORE THE ASSEMBLY
1. Before starting work, switch off the
ignition and remove the ignition key. If
necessary, remove the main power
switch.
2. Disconnect the negative terminal of the
battery. Do not allow the battery to be
reconnected by mistake.
3. When mounting the device in the vicinity
of a magnetic compass, maintain a
protective distance from the compass.
4. Purchase an NMEA 2000 drop cable
with five-pin M12 connector (max drop
cable length 6 m) and a video cable with
a compatible four-pin M12 connector
(A2C1845710001).
WARNING
INSTALLATION
A2C15587600