Veratron OCEANLINK 4.3 Benutzerhandbuch Seite 16

STARTUP CHECKLIST
Following are the steps for initial configuration:
1. Connect any sensors to analog inputs.
2. Set up general device operations (see "System settings").
3. Add/remove data pages selecting the best layout and data to be viewed (see "Data
page configuration").
4. If a page layout with bar graphs is used, customize the minimum and maximum
intervals (Bar graph settings, see "System settings").
5. Enable/disable local input and NMEA 2000 and J1939 alarms (see "Alarm
management").
UPLOAD A CUSTOM SPLASH LOGO
A custom splash logo can be loaded from a PC using the veratron Configuration Tool.
For more information, please refer to the veratron Configuration Tool user manual or
contact your veratron reseller.
GETTING STARTED
A2C15587600