Veratron OCEANLINK 4.3 Benutzerhandbuch Seite 25

OPERATING THE SYSTEM CONFIG MENU
NOTE: the underlined value/command is the factory default one.
Setting
Display >
Illumination
Display >
Bargraph settings
Units
Damping >
Wind damping/
Heading damping
Clock >
Clock format
Clock >
Clock offset
EasyLink
J1939 Gateway
Reset >
Reset factory
Reset >
Reset Trip time
Reset >
Reset Trip Distance
Reset >
Reset Trip Fuel
Description
Brightness of the display.
NOTE: this setup affects all the
EasyLink gauges too.
Bar graphs minimum and
maximum setup.
Unit of measure for the
displayed data.
Damping for wind and heading
displayed data.
Clock format.
Time zone setup.
Which engine and tanks are to
be displayed on the EasyLink
gauges.
Configuration for the SAE
J1939 to NMEA 2000 gateway.
All the data received from the
J1939 bus will be sent on
NMEA 2000 with the instance
specified here.
Reset the display to factory
default.
Possible values / commands
0–7, Auto
•
Boost press: 0–13 bar (default = 0–1)
•
Engine temp 0–300 °C (default = 0–200)
•
Battery voltage 8–32 V (default = 10–16)
•
Fuel flow 0–800 l/h (default = 0–150)
•
Metric
•
Imperial
•
Nautical
• Custom: completely customizable
• No
•
Low
•
Medium
•
High
•
12 h
•
24 h
From -12h to +12 h (0 h)
• Show engine data from: Engine 1–4
• Show fuel from: Tank 1–4
•
Show fresh water from: Tank 1–4
•
Show waste water from: Tank 1–4
Send to NMEA 2000 As:
•
Auto: the display keeps the J1939 engine
identifier also for the NMEA 2000 network.
•
Engine 1–4
•
Yes
• No
• Yes
•
No
• Yes
•
No
•
Yes
•
No
SYSTEM SETTINGS
A2C15587600