Charging Process; Operation - Parkside PGSA 4 A2 Originalbetriebsanleitung

h) Avoid mechanical dama-
ge to the charger. This can
result in internal short circuits.
i) Do not operate the char-
ger on a combustible
surface (e.g. paper, tex-
tiles). Risk of fire due to hea-
ting during charging.
j) Do not use the charger to
charge non-rechargeable
batteries.
k) Do not connect a dama-
ged cable to the power
supply. Do not touch a
damaged cable before
it has been disconnected
from the power supply,
as you could come into
contact with active parts.

Charging process

Do not expose the battery to
extreme conditions such as
heat and impact. There is a risk
of injury from leaking electro-
lyte solution! In case of contact,
rinse with water or neutraliser
and consult a doctor if contact
has occurred with eyes etc.
Charge the battery only in
dry areas.
Do not switch on the device
while charging it.
There is a risk of injury from
electric shock.
The rechargeable battery reaches
its full capacity only after it was
charged several times.
The safety key must be inserted dur-
ing the charging process.
• Before initial use, charge the battery in-
stalled in the equipment. Do not charge
the battery for several short periods in
succession.
• Use the charger supplied to charge the
Li-ion battery installed in the equipment.
• Recharge the battery if the equipment
runs too slowly.
• In all cases, observe the applicable safety
information as well as the regulations and
directions for environmental protection.
• Defects resulting from improper han-
dling are not subject to the guarantee.
1. Insert the safety key (7).
2. Connect the charger cable plug
(15) with the charger socket on
the tool (6).
3. Connect the power supply unit
(14) to a socket.
The charging indicator (2) lights up:
Red: Equipment charging.
Green: Charging finished.
The recommended charging time
is approx. 1 hour.
This charging time can only
be achieved using the power
adapter.
4. After the recharging process is
completed, first unplug the charg-
er from the wall outlet, and then
remove the charger cable plug
(15) from the tool.

Operation

Keep to noise abatement regulations
and other by-laws.
GB IE
31