Refilling Water; Switching Off The Device; Allow The Device To Cool Down; Drain The Water Reservoir - Kärcher SC 4 Deluxe EasyFix Originalbetriebsanleitung

Switching on the device
Note
If there is no or too little water in the steam
boiler, the water pump starts to run and
pumps water from the water reservoir into
the steam boiler. The filling process can
take several minutes.
Note
The device briefly closes the valve every 60
seconds causing an audible soft click. Clos-
ing prevents the valve from clogging. This
does not affect the steam output.
1. Place the device on a firm surface.
2. Insert the main plug into a socket.
3. Turn the selector switch from the OFF
position to the steam setting selection
range.
Illustration D
The LED strip is in fading red.
4. The LED light lights up a continuous
green after approx. 3 minutes.The de-
vice is ready for use.
Illustration E
5. Press the steam lever.
Illustration F
Steam leaks out.
Regulating the steam volume
The expelled steam volume is regulated us-
ing the selector switch for steam volume.
The selector switch has three positions.
Maximum steam volume
Medium steam volume
Minimum steam volume
1. Set the selector switch for the steam vol-
ume to the required steam volume.
2. Press the steam lever.
3. Before cleaning, point the steam gun at
a cloth until steam is expelled evenly.

Refilling water

If there is not enough water in water reser-
voir, the LED light rapidly flashes red and a
signal tone sounds.
16
Note
The water pump fills the steam boiler at in-
tervals. If the filling is successful, the LED
light is quick flashing red.
Note
If there is no or too little water in the steam
boiler, the water pump starts to run and
pumps water from the water reservoir into
the steam boiler. The filling process can
take several minutes.
ATTENTION
Damage to the device
Unsuitable water can block the nozzles or
damage the water level indicator.
Do not fill in pure distilled water. Use a max-
imum of 50% distilled water mixed with tap
water.
Do not use condensation from the clothes
dryer for filling.
Do not use collected rain water for filling.
Do not use cleaning agents or other addi-
tives (e.g. scents) for filling.
1. Fill the water tank with tap water or a
mixture of tap water and no more than
50% distilled water.
The device is ready for use.

Switching off the device

1. Turn the power switch to the "OFF" posi-
tion.
Illustration L
The device is switched off.
2. Press the steam lever until steam is no
longer released.
Illustration M
The steam boiler is depressurised.
3. Move the child lock back.
The steam lever is locked.
4. Pull the main plug out of the socket.

5. Drain the water reservoir.

Rinsing out the steam boiler
Rinse the device's steam boiler out after
every tenth filling of the tank.
1. Switch the device off; see Chapter
Switching off the device.

2. Allow the device to cool down.

3. Drain the water reservoir.
4. Remove the accessory / accessories
from the accessory storage area.
English