Care And Service - Kärcher SC 4 Deluxe EasyFix Originalbetriebsanleitung

a Place the floor cleaning cloth with the
hook and loop fastener strips pointing
upwards on the floor.
b Place the floor nozzle onto the floor
cleaning cloth, applying slight pres-
sure.
Illustration J
The floor cleaning cloth will stick to the
floor nozzle of its own accord due to the
hook and loop fastener.
Removing the floor cleaning cloth
1. Place one foot on the bottom corner of
the floor cleaning cloth and lift the floor
nozzle up.
Illustration J
Note
Initially, the floor cleaning cloth's hook and
loop fastener strip is very strong and cannot
be removed from the floor nozzle easily. Af-
ter the floor cleaning cloth has been used
several times and washed, it is easier to re-
move from the floor nozzle and it has
reached the optimum adhesion.
Parking the floor nozzle
1. Hang the floor nozzle in the park bracket
during breaks in work.
Illustration O
Carpet glider
The carpet glider is used for freshening up
carpets.
ATTENTION
Beware of damaging the carpet glider
and carpet
Contamination on the carpet glider, as well
as heat and moisture penetration, can re-
sult in the carpet being damaged.
Prior to the application, also check the heat
resistance and impact of steam on the car-
pet at an insignificant spot using as small
an amount of steam as possible.
Observe the cleaning instructions from the
carpet manufacturer.
Prior to using the carpet glider, make sure
that the carpet has been vacuumed and
that stains have been removed.
Prior to application and following operating
pauses, remove any possible water accu-
mulation (condensate) in the appliance by
means of evaporating the condensate into
a drain (without floor cleaning cloth / with
accessories).
Only use the carpet glider with a floor
cleaning cloth on the floor nozzle.
Steam clean with a weak steam stage when
using the carpet glider.
In order to prevent too much moistening
and to avoid the risk of damage due to tem-
perature effects, do not direct the steam
continuously onto one spot (maximum
5 seconds).
Do not use the carpet glider on deep-pile
carpets.
Fastening the carpet glider to the floor
1. For fastening the floor cleaning cloth to
the floor nozzle, please refer to chapter
Floor nozzle.
Illustration J
2. Using a little force, allow the floor nozzle
to slide into the carpet glider and engage
there.
Illustration K
3. Start cleaning the carpet.
Removing the carpet glider from the
CAUTION
Beware of burns to your feet
The carpet glider can heat up during the
steaming process.
Do not operate or remove the carpet glider
bare-footed or using open sandals.
Only operate or remove the carpet glider
using suitable footwear.
1. Press the strap on the carpet glider
downwards using the front of toe-
capped shoes.
2. Lift the floor nozzle upwards.
Illustration J

Care and service

Descaling the steam boiler
Note
Descaling the steam boiler is not required if
commercially available distilled water is
used.
English
nozzle
floor nozzle
19