Refilling Water; Turning Off The Appliance; Storing The Appliance - Kärcher SC 1.030 Kurzanleitung

Adjusting the Steam Quantity
Use the selector switch for the steam vol-
ume to regulate the discharged steam. The
selector switch has three positions:
Maximum steam volume
Reduced steam volume
No steam - child protection
Note: In this lever position, the steam
lever cannot be used.
 Set selector switch to the required
steam volume.
 While operating the steam switch, al-
ways direct the steam gun at a separate
piece of cloth until the steam is emitted
evenly.
Note: The heating of the steam cleaner
is turned on in regular intervals during
the operation of the appliance in order
to maintain the pressure in the boiler at
a constant level. When the heating is
turned on, the orange indicator lamp
(heater) lights up.

Refilling Water

Water needs to be filled into the boiler, if the
steam volume decreases during work and
no more steam is emitted in the end.
Note: The safety lock cannot be opened as
long as slight pressure remains in the boil-
er.
 Push the steam switch until steam dis-
charge stops. Now, the boiler of the ap-
pliance is unpressurized.
 Disconnect the mains plug from the
socket.
 Remove the safety cap from the device.
Danger
A residual amount of steam may be emitted
when you open the safety lock. Be careful
when opening the safety lock, there is a risk
of scalding.
 Fill the boiler with a maximum of 1 liters
of fresh tap water.
18
Danger
If the boiler is hot, there is the risk of scald-
ing as the water may splash back during
the filling process! Do not fill any detergents
or other additives into the boiler!
 Screw the safety cap back onto the de-
vice.
 Insert the mains plug into a socket.
 The orange indicator lamp goes out af-
ter approximately 8 minutes.
The steam cleaner is ready to use.

Turning Off the Appliance

 Disconnect the mains plug from the
socket.
 Press the cover of the appliance con-
nector to the bottom and disconnect the
steam plug from the appliance connec-
tor.

Storing the Appliance

 Illustration
Put the extension pipes into the large
–
accessory compartments.
Insert the manual nozzle and detail noz-
–
zle onto each extension pipe.
Put the round brush into the medium
–
acessory compartments.
Hook the floor nozzle into the parking
–
position.
Wrap the steam hose around the exten-
–
sion pipes and insert the steam pistol
into the floor nozzle.
– 9
EN