Fixture Rotation; Dismounting Panels; Mounting The Condensation Discharge Device In The Horizontal Version; Dismantling The Heating Plate (Slr Smart Model Only) - Olimpia splendid Bi2 SL SMART S1 Serie Installationsanweisung Und Wartung

N.B. for the horizontal installation carefully note the following precautions:
- make sure that the machine is installed perfectly level or with a slight inclination towards the
condensation discharge;
- insulate carefully the inflow and outflow pipes up to the machine union to prevent any drops of
condensation outside the same collection bowl;
- insulate the bowl condensation discharge pipe along all of its length.

2.9 - FIXTURE ROTATION

The operations described and the relative images refer to a machine with fixtures on the left on which the
fixtures on the right side must be rotated.
If there is a machine available with right side fixtures that require rotation to the left, the sequence of the
operations is the same, only the images are a mirror image.
To connect the motor to the control kit, use the special cabling (optional).

2.9.1 - Dismounting panels

- Lift the cover (fig. 15 ref. H) that protects the screw (fig. 15 ref. L) and unscrew it.
- Move the side panel slightly to the right and lift it out (fig. 15 ref. P).
- Remove the air filters on the lower side (fig. 16 ref. A);
- Undo the screws (fig. 16 ref. B) that secure the front panel (fig. 16 ref. C) and remove by pulling it out from
the lower hook (fig. 16 ref. M);
- Remove the battery upper insulation (fig. 16 ref. D);
- Unscrew the top inlet connector (fig. 17 ref. A)
- Unscrew the bottom outlet connector (fig. 17 ref. B)
- Take out the plate with the heating coil (fig. 17 ref. C).
2.9.2 - Dismantling the heating plate (only for SLR SMART)
- Dismount all the collector units (fig. 18 ref. A)
2.9.3 - Dismounting control panel (if present)
- Position the system master switch to OFF.
- Remove the door giving access to the collector units (fig. 19 ref. A) by undoing the fixing screw (fig. 19
ref. B).
- Dismount the control panel (fig. 19 ref. C) unscrewing the two fixing screws (fig. 19 ref. D) and relative
electrical box.
- Unplug the connectors of the electrical connections.
- Remove the cables inside the machine and re-insert them from the opposite side.
- For the motor connection, use the special cable for right hand fixtures, available as an accessory.
- Invert the mounting positions of the door (fig. 19 ref. A) with the control panel (fig. 19 ref. C) and remount
them in their respective positions.
- Dismount the condensation collection tray (fig. 19ref. F) and remount it on the opposite side with the relative
fixing screws (fig. 19 ref. G).
- Remove the control E and reassemble it from the opposite side in the respective position with the relative
screws
EN - 45
Bi2 SL/SLR-SMART S1