Mount The Top Case; Case And Then Align The; Claws Of The Bottom Case; Avoid The - Panasonic CZ-RTC6 Installationsanleitung

3

Mount the top case.

● Align the claws of the top

case and then align the

claws of the bottom case.

● If the wiring is difficult to
move, loosen the screw in
the lower case, work on the
wiring, then screw in the
screw after finishing the work.

Avoid the

wire being

caught.
Claw (2 places)
2

Connect the remote control wiring.

• Be sure not to allow unnecessary wires to
remain in the remote controller case when
wiring. Be careful not to allow wires to be in
contact with parts on the PCB. For connection
method, refer to "Connection to the remote
controller terminal board" in "Attention".
8
(EN)
Embedded type
1 Mount the bottom case to
the wall.
● Pass the wire through the
wiring hole in the bottom case.

Hole for screw

• Insert the clamper from the
Claw (2 places)

position indicated by the arrow,

Screw

as shown in the diagram at right.

(Supplied)
• Put the locking part of the

clamper in the channel as

indicated by the arrow.

• If you lock at the top, it may not

be possible to close the bottom

case.
*It is also possible to mount in the order
Pass the wire under the rib.

Remove the coating. Approx. 9 mm

● Make sure the wiring connection
is in the correct direction.
2
→

Remote controller

terminal board
Clamper
(supplied)
3
1 → .