Operating The Device Safely - Dometic BUTTNER MT StandbyChargerPRO Montage- Und Bedienungsanleitung

MT StandbyChargerPRO
• If you are working on electrical systems, ensure that there is somebody close at hand
who can help you in emergencies.
!
WARNING! Failure to obey these warnings could result in death or serious
injury.
Electrocution hazard
• Observe the recommended cable cross-sections.
• Lay the cables so that they cannot be damaged by the doors or the hood.
Crushed cables can lead to serious injury.
A
NOTICE! Damage hazard
• Use ductwork or cable ducts if it is necessary to lay cables through metal panels or
other panels with sharp edges.
• Do not lay the 230 V mains cable and the 12 V DC cable in the same duct.
• Do not lay the cable so that it is loose or heavily kinked.
• Fasten the cables securely.
• Do not pull on the cables.
2.4

Operating the device safely

!
WARNING! Failure to obey these warnings could result in death or serious
injury.
Explosion hazard
• Only use the device in closed, well-ventilated rooms.
!
CAUTION! Failure to obey these cautions could result in minor or moderate
injury.
Explosion hazard
• Do not operate the device under the following conditions:
– In salty, wet or damp environments
– In the vicinity of corrosive fumes
– In the vicinity of combustible materials
– In areas where there is a danger of explosions
Electrocution hazard
• Always disconnect the power supply when working on the device.
• Observe that parts of the device may still conduct voltage even if the fuse has blown.
• Do not disconnect any cables when the device is still in use.
A
NOTICE! Damage hazard
• Ensure that the air inlets and outlets of the device are not covered.
• Ensure a good ventilation.
• Never pull the plug out of the socket by the connection cable.
• The device shall not to be exposed to rain.
EN
Safety instructions
9