Operating The Device Safely - Dometic POWER & CONTROL SMP439-11 Montage- Und Bedienungsanleitung

Safety instructions
A
NOTICE!
• If cables have to be fed through metal walls or other walls with sharp
edges, use ducts or bushings to prevent damage.
• Do not lay cables which are loose or bent next to electrically conduc-
tive material (metal).
• Do not pull on the cables.
• Do not lay the AC mains cable and the DC cable in the same duct.
• Set up the device in a dry location where it is protected against splash-
ing water.
• Protect the device and the cable against rain and moisture.
• Store the device in a dry and cool place.
2.3

Operating the device safely

D
DANGER! Danger of electrocution
• Do not touch exposed cables with your bare hands. This applies espe-
cially when operating the device from the AC mains.
• To be able to disconnect the device quickly from the mains, the socket
must be close to the device and be easily accessible.
!
WARNING!
• Do not operate the device in systems with lead acid batteries. These
batteries give off explosive hydrogen gas that can be ignited by sparks
on electrical connections.
!
CAUTION!
• Do not operate the device
– In wet or damp environments
– In the vicinity of corrosive fumes
– In the vicinity of combustible materials
– In areas where there is a danger of explosions.
• Before starting the device, ensure that the power supply line and the
plug are dry.
• Always disconnect the power supply when working on the device and
ensure that the device is voltage-free.
• Please observe that parts of the device may still conduct voltage even
if the fuse has blown.
• Do not disconnect any cables when the device is still in use.
8
SMP439-11 (7LA.915.681)
EN