Operating The Device Safely - Dometic SMP439 Montage- Und Bedienungsanleitung

SMP439, 439-08
• Make sure that the lead has a sufficient cross-section.
• Lay the cables so that they cannot be tripped over or damaged.
• Fasten the cables securely.
• Do not expose the device to a heat source (such as direct sunlight or
heating). Avoid additional heating of the device in this way.
A
NOTICE!
• If cables have to be fed through metal walls or other walls with sharp
edges, use ducts or bushings to prevent damage.
• Do not lay cables which are loose or bent next to electrically conduc-
tive material (metal).
• Do not pull on the cables.
• Do not lay the AC mains cable and the DC cable in the same duct.
• Set up the device in a dry location where it is protected against splash-
ing water.
• Protect the device against corrosive fumes and salty or moist air.
• Protect the device and the cable against rain and moisture.
• Store the device in a dry and cool place.
2.3

Operating the device safely

D
DANGER! Danger of electrocution
• Do not touch exposed cables with your bare hands. This applies espe-
cially when operating the device from the AC mains.
• To be able to disconnect the device quickly from the mains, the socket
must be close to the device and be easily accessible.
!
WARNING!
• Only use the device in closed, well-ventilated rooms.
• Do not operate the device in systems with lead acid batteries. These
batteries give off explosive hydrogen gas that can be ignited by sparks
on electrical connections.
!
CAUTION!
• Do not operate the device
• In salty, wet or damp environments
• In the vicinity of corrosive fumes
• In the vicinity of combustible materials
EN
Safety instructions
9