Operation - CMi C-B-RM-51HMA Originalbetriebsanleitung

NOTICE! Risk of damage to the
device! The unit is delivered without
motor oil.
Motor oil must be filled before starting
the machine.
Note: Only use suitable fuels (► Fuel
and lubricants to be used – p. 51).
– Unscrew the tank lid (11) and remove.
– Carefully top up the fuel (tank contents:
► Technical data – p. 50). Do not spill!
– Check the seal in the tank lid for dam-
ages, and clean if necessary. Immediately
replace damaged seals!
– Tighten the tank lid (11) by hand.
Filling with motor oil
► P. 3, item 2
– Unscrew the motor oil filling screw (15)
and remove.
– Carefully top up the motor oil (tank con-
tents: ► Technical data – p. 50). Do not
spill!
– Tighten the motor oil filling screw (15) up
again by hand.
Set the cutting height
► P. 5, item 6
The cutting height can be set to several differ-
ent heights (Cutting heights: ► Technical
data – p. 50).
– Pull the lever (6) to the side.
– Set the cutting height to the value you
require, and let the lever slot back into
place.
Attach the collection box
► P. 5, item 7
– Lift the protective flap (7) and hold.
– Hook in the collection box (8).
– Make that the collection box is securely
engaged.
Mounting the ejection opening
Note: When using the ejection open-
ing, the mulching wedge and collec-
tion bag are not needed.
Cut material is distributed across the
lawn.
► P. 6, item 8
– Press the unlocking button (33).
– Lift the flap (25).
– Insert the ejection opening (5).
Mounting the mulching wedge
► P. 6, item 9
– Remove the collection bag.
– Insert the mulching wedge (26) into the
opening of the unit until it engages.
– Lower the protective flap (7).

Operation

Check before starting the device!
DANGER! Risk of injury! The
device may only be put into operation
if there are no defects. If a part is
defective it must be replaced before
the device is used again.
Check to make sure the device is in safe
operating condition:
– Check to make sure there are no visible
defects.
– Check to make sure all device compo-
nents are correctly mounted.
Starting the motor
► P. 3, item 2
DANGER! Danger of fire! Spilled
fuel can set the product on fire.
Carefully wipe up any spilled fuel up
before starting.
Start the product a minimum of nine
metres away from where you filled it.
Note: In case of start-up difficulties,
please refer to the following able:
► Troubleshooting – p. 49
Note: Pull the pull starter out and
slowly guide it back using your hand.
– Slightly press fuel pump (12) approx. 3–
5×.
– Engage and firmly hold the switch-on
bar (1) up to the stop.
– Slow pull out the pull starter (9) until you
feel a resistance, then quickly and force-
fully, until the initial ignition noise can be
heard.
– Pull out the pull starter again quickly and
forcefully until the motor starts up.
– Allow the engine to warm up for approx.
10–15 seconds.
Switching off the motor
► P. 3, item 2
WARNING! Risk of injury! Always
switch off the product when not in use
for short periods.
– Release the switch-on bar (1).
GB
47