CMi C-B-RM-51HMA Originalbetriebsanleitung Seite 51

Part number
Vibration**
Spark plug
*) The noise emission values indicated have been measured
according to a standardized test method and can be used to
compare one power tool with another. The noise emission val-
ues indicated can also be used for a preliminary assessment of
the exposure. Warning: The noise emissions during the actual
use of the power tool may differ from the indicated values,
depending on the way in which the power tool is used, in particu-
lar what type of workpiece is being machined. Safety measures
must be defined to protect the operator, based on an estimation
of the vibration load during actual conditions of use (taking into
consideration all parts of the operating cycle, such as time peri-
ods when the power tool is switched off and time periods when
it is switched on but running without a load).
**) The specified vibration emission value was measured in accord-
ance with a normed test procedure and can be used in order to
compare one tool with another. The specified vibration emission
value can also be used for an introductory evaluation of the
exposure. The vibration emission value may fluctuate from the
specified value during actual use of the power tool. These fluc-
tuations will depend on the way in which the power tool is used.
Try to keep vibrations to a minimum. One method of reducing
the vibration load is, for example, limiting the length of time you
work with the tool. All parts of the operating cycle must be taken
into account for this purpose (for example, also including times
in which the power tool is switched off and times in which it is
switched on, but is running without load). Determination of vibra-
tion emission values in accordance with EN 5395-1 & EN5395-
2.
Fuel and lubricants to be used
NOTICE! Risk to the environment,
fire hazard! Prevent damage from
occurring due to leaking fuel: Make
sure the tank is completely drained
before disposing of the device.
NOTICE! Risk of product damage!
Never use Bio-Ethanol E85 as fuel!
• Ordinary petrol, lead-free, 90 Octane If
there is no ordinary petrol available, use
petrol with a higher octane level.
• Motor oil: SAE 10W-30
Instructions for fuels
Fuels with ethanol mixtures (e. g. E10)
Fuels with high ethanol mixture are more
aggressive than fuels with less or without eth-
anol mixture. Possibly painted surfaces and
plastics can be strongly affected or damaged.
Moreover, fuel with ethanol mixture strongly
reacts to influential factors such as light rays,
temperature and storage time. Hence, these
fuels should be stored only in allowed con-
tainers and in suitable place for not more than
30 days.
It is recommendable to empty the fuel tank as
well as the steam separator (carburettor) if
combustion engine takes longer time to shut-
down.
All our devices are suitable for using the E10
fuel.
234861
6,11 m/s² (K =
1,5 m/s²)
F5RTC
F7RTC
GB
51