Your Device At A Glance; Assembly; Operation - CMi C-ERM-1200/32 Originalbetriebsanleitung

Rasenmaeher_Elektro_302150_115215.book Seite 31 Freitag, 23. Oktober 2015 8:46 08
• Remember that when using a tool with
multiple blades, moving one blade may
lead to the other blades rotating.
• When adjusting the machine, make sure
that no fingers are trapped between the
moving blades and fixed parts of the
machine.
• Allow the motor to cool down before you
put the machine away.
• When maintaining the blades, remember
that even if the power source is deacti-
vated, the blades can still be moved.
• For safety reasons, replace worn or dam-
aged parts. Only use original spare parts
and accessories.

Your device at a glance

► P. 3, item 1
1. Operating lever
2. Handle bar
3. Strain relief mechanism for extension
cable
4. Handle bar, bottom part
5. Protective flap
6. Collection box
7. Mains plug
8. Operating safety lock
Scope of delivery
• Operating manual
• Lawn-mower
• Handle, lower section
• Handle
• Collection box
• Bag containing small parts
DANGER! Risk of death through
electric shock! The use of this vari-
ant outside Switzerland is not per-
missible for safety reasons, as this
poses a risk of electric shock or fire.
The variant of the product sold in
Switzerland may only be used in
Switzerland, as it is equipped with a
Swiss plug.
You can identify the variant by
means of the item number on the
product (the instructions always con-
tain all item numbers):
Item number Switzerland: 115 215
Item number in other EU countries:
302 150

Assembly

Mounting the handle
► P. 4, item 2
– Position the bottom part of the handle
bar (4) into the locators on the product
and tighten with screws (9).
► P. 4, item 3
– Push the cable grip (3) onto the handle
bar (2).
– Position the handle bar (2) onto the bot-
tom part of the handle bar and push
through the carriage bolts (10).
– Position the toggle nuts (11) and tighten.
Mounting the collection box
► P. 5, item 4
– Pull the collecting sack (6) over the wire
frame (12) as shown.
– Clip the collecting sack to the wire frame
as shown.

Operation

Check before starting the device!
DANGER! Risk of injury! The
device may only be put into opera-
tion if there are no defects. If a part is
defective it must be replaced before
the device is used again.
Check to make sure the device is in safe
operating condition:
– Check to make sure there are no visible
defects.
– Check to make sure all device compo-
nents are correctly mounted.
Preparation
Set the cutting height
The cutting height can be set to several dif-
ferent heights (Cutting heights: ► Technical
data – p. 33).
► P. 5, item 5
– Allow the axles (13) to engage at the
desired height.
Attach the collection box
► P. 6, item 6
– Lift and keep hold of the protective
flap (5).
– Hook in the collection box.
– Make that the collection box is securely
engaged.
Connecting the product
► P. 6, item 7
GB
31