Your Device At A Glance; Assembly; Commissioning - CMi C-B-RM-51HMA Originalbetriebsanleitung

GB
• Operating the machine at excess speed
can increase the risk of accident.
• When turning on the machine, make sure
that your fingers are not caught between
the moving cutting blades and fixed parts
of the machine.
Maintenance and storage
• Make sure that all nuts, bolts and screws
are firmly tightened. You will then know
that the product is in a safe working con-
dition.
• While petrol is in the tank, never store the
lawnmower in a building in which petrol
vapours may come into contact with
naked flames or sparks or can be easily
ignited.
• To avoid the risk of fire keep the motor,
exhaust, and petrol tank area away from
grass, leaves, and leaking grease (oil).
• Regularly check the grass catcher for
wear or loss of functionality.
• Let the motor cool before turning off the
machine.
• When maintaining the cutting blades,
please note that the cutting blades can be
moved even when the machine is
switched off.
• For safety reasons always replace worn
or damaged parts. Use only original spare
parts and accessories.
• Should the tank need draining, do so out-
doors using a petrol suction pump.

Your device at a glance

Note: The actual appearance of your
product may differ from the illustra-
tions.
► P. 3, item 1
1. Switch-on lever
2. Handle
3. Handle, lower section
4. Motor
5. Ejection opening
6. Lever for adjusting the cutting height
7. Protective flap
8. Collection box
9. Pull starter
10. Clutch lever for travel drive
► P. 3, item 2
11. Fuel filter nozzle
12. Fuel pump
13. Air filter cover
46
14. Ignition cable with spark plug
15. Motor oil filling screw
Scope of delivery
• Operating manual
• Lawn-mower
• Handle
• Handle, lower section
• Assembly wrench
• Collection box
• Bag containing small parts

Assembly

Mounting the handle
Note: All mounting steps must be
performed on both sides.
Note: Place the bottom part of the
handlebar on the machine as shown
in such a way that the pull starter
holder is on the right side.
► P. 4, item 3
– Position the bottom part of the handle
bar (3) into the locators on the product
and push through the carriage bolts (16).
– Position the toggle nuts (17) and tighten.
► P. 4, item 4
– Position the handle bar (2) onto the bot-
tom part (3) of the handle bar and push
through the carriage bolts (19).
– Position the toggle nuts (20) and tighten.
– Tighten the pull starter holder (18) as illus-
trated and attach the pull starter (9).
Mounting the collection box
► P. 5, item 5
– Screw the handle (21) firmly to the cover
with 2 screws (22), as illustrated.
– Attach the collection bag (24) to the col-
lection basket upper (23).
– Press the rubber lip as far as possible into
the guide!

Commissioning

Filling with fuel
► P. 3, item 2
DANGER! Risk of injury! Petrol is
extremely flammable!
Switch off the motor and allow to cool
down before refilling.
Observe all of the safety notes for
handling fuels.