Spirit XE 295 Benutzerhandbuch Seite 59

Even stand
Check that the unit is properly leveled. You may adjust the device by the leveling pads on the
stabilizers.
WARNING
The safety level of the equipment can only be maintained if it is examined for damage and
wear on a regular base. Replace defective components immediately and keep the equipment
out of use until repair. These parts are particularly prone to wear: Belt, PU wheel, bearing,
idler, shaft and pedals.
MAINTENANCE MODE MENU
The console has built-in maintenance/diagnostic software. The software will allow you to change the
console settings from English to Metric and turn off the beeping of the speaker when a key is pressed for
example. To enter the Maintenance Mode, pedal the elliptical and press and hold down the Start, Stop
and Enter keys. Keep holding the keys down for about 5 seconds and the Message Center will display
Engineering Mode Menu. Press the Enter key to access the menu below:
1. Key Test (Will allow you to test all the keys to make sure they are functioning)
2. LCD Test (Tests all the display functions)
3. Functions (Press Enter to access settings and Up arrow to scroll)
i. Display Mode (Turn off to have the console power down automatically after 20 minutes of inactivity)
ii. Pause Mode (Turn on allow 5 minutes of pause, turn off to have the console pause indefinitely)
iii. ODO Reset (Resets the odometer)
iv. Units (Sets the display to readout in English or Metric display measurements)
v. Beep (Turns off the speaker so no beeping sound is heard)
vi. Safety
d. Security (Allows the keypad to be locked to prevent unauthorized use)
59