Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Step 1: Rail & Console Mast
1.
Locate the CONSOLE MAST (12) and CONSOLE MAST COVER (72); put the cover onto the mast
using the screws (120). Make sure the CONSOLE MAST COVER (72) is correctly orientated.
2.
At the top opening of the MAIN FRAME (1), there is the COMPUTER CABLE (50) tied to a tie wire.
Guide the tie wire with the COMPUTER CABLE (53) into the bottom of the CONSOLE MAST (12)
and out of the opening at the top.
3.
Install the CONSOLE MAST (12) onto the bracket on the top of the MAIN FRAME (1). Be extremely
careful not to pinch any cables!
NOTE: Maybe there is one bolt already installed on the bracket that will engage with the slot at the
bottom of the Console Mast. This needs to be tightened last, after the other mast bolts.
4.
Place a SPLIT WASHER (152) onto the BOLT (105) and hand tighten through the left side of the
console mast. Place a CURVED WASHER (153) onto each BOLT (103) and thread both into the front
of the console mast tube. Fasten these front bolts as tight as possible with the WRENCH (155). Next
tighten the two left side bolts with the same wrench firmly.
5.
Connect the 2 HAND PULSE CABLES (47), RESISTANCE CABLE (49), and COMPUTER CABLE
(53) to the back of the CONSOLE (43). Do not force the connectors; they will only fit one way and are
different sizes to prevent confusion. Place the excessive cable in the CONSOLE MAST TUBE (12).
6.
Attach the CONSOLE (43) to the bracket of the Console Mast tube with 4 PHILLIPS HEAD SCREWS
(116). Tighten the screws using the PHILLIPS HEAD SCREW DRIVER (157).
7.
Attach the END CAPS (93) to the device as shown if not already in place.
8.
Slide the Rail Assembly into the MAIN FRAME (1). Insert one BUTTON HEAD SOCKET BOLT (176)
and a FLAT WASHER (137) through each side and attach the BOLTS (130) with CURVED
WASHERS (153) to each joint on the inside as shown in drawing.
Needed Hardware for this step:
#137. 3/8" × 19 × 1.5T
Flat Washer (2 pcs)
#152. 3/8" × 2T
Spilt Washer (1 pc)
#116. M5 × 10m/m
Phillips Head Screw
(4 pcs)
#103. 3/8" × 3/4"
Hex Head Bolt (2 pcs)
#130. 3/8" × 3-3/4"
Button Head Socket Bolt
(4 pcs)
#153. 3/8" × 23 × 2T
Curved Washer (6 pcs)
#120. 3.5 × 16m/m_
Sheet Metal Screw (3 pcs)
40
#176. 3/8" × 2-1/4"
Button Head Socket Bolt
(2 pcs)
#105. 3/8" × 2-1/4"
Hex Head Bolt (1 pc)
Werbung
Inhaltsverzeichnis
