Spirit XE 295 Benutzerhandbuch Seite 43

Step 3: Handgrips
1. Slide the RUBBER SLEEVE (162) onto the LEFT (16) and RIGHT (17) UPPER SWING ARMS.
Make sure the wide part is at the bottom.
2. Attach the WIRE (50) from the RIGHT UPPER SWING ARM (17) to the WIRE(49) that exits the
CONSOLE MAST TUBE (12). Slide the SWITCH WIRE CAP (161) onto the wire with the wide
side facing the Swing Arm.
3. Fix UPPER SWING ARM (17) on Lower Swing Arm (11) with 3 HEX HEAD BOLTS (159), 2
CURVED WASHERS (160) and 3 NYLOC NUTS (127) as shown.
4. Repeat step 3 from above on the left side.
Needed Hardware for this step:
#127. 5/16" × 7T
Nyloc Nut (6 pcs)
#159. 5/16" × 1-3/4"
Hex Head Bolt (6 pcs)
#160. 5/16" × 23 × 1.5T
Curved Washer (4 pcs)
43
Switch Wire
#161.
Cap
(1 pc)