Caution!
Danger of injury: The following parts are hot or may become hot:
•
area around the steam handle and the hot water handle
•
steam and hot water wands
•
portafilter
•
brew group
•
body (upper part and side frames)
3.2 Technical data
Voltages:
EU: 230 V
UK: 230 V
NZ: 230 V
AU: 230 V
US: 115 V
JP: 100 V
Power:
Water tank:
Boiler volume:
Measurements:
Measurements with portafilter:
Weight:
4
MACHINE INSTALLATION
4.1 Preparation for installation
• Place the machine on an even and stable surface.
• Ensure that the machine is on a water-resistant surface in case of water spillage or
leakage.
• Do not place the machine on hot surfaces.
4.2 Electrical connection
• Ensure that the local main voltage supply corresponds to the information on the
machine label on the front panel of the espresso machine.
• Ensure that you use the correct power plug for your country.
• Plug the machine into a grounded socket only and do not leave it unattended.
• Do not roll or bend the power cord.
• Do not use a power extension cord or a multiple socket.
5
FIRST USE
Read the instruction manual carefully prior to operating the machine.
Prior to starting the machine, check if:
• the steam and hot water valves are closed.
• the machine is switched off. (Power switch in lower position.)
• the power cord is disconnected.
• the drip tray is inserted correctly.
• the machine is placed on a water resistant surface.
Now you can start up your machine:
1
Open the cup warmer tray.
2
Take out the water tank and rinse thoroughly.
3
Fill the water tank with fresh water low in lime, place it back into the water tank guides and close the
cup warmer tray.
4
Insert the power plug into the wall socket. Turn the power switch to "ON". The machine is now on.
Translation of the original German user manual
Frequency:
EU: 50 Hz
UK: 50 Hz
NZ: 50 Hz
AU: 50 Hz
US: 60 Hz
JP: 50/ 60 Hz
1400 W
approx. 2.8 l
1.6 l
W 228 mm x D 448 mm x H 372 mm
W 228 mm x D 558 mm x H 372 mm
21.5 kg
ENGLISH
28