Troubleshooting - Steinbach Premium 100 Originalbetriebsanleitung

Troubleshooting

Problem
The pressure on the
manometer exceeds 1 bar.
Air bubbles escape from the
injection nozzle.
The pump is not getting
enough water or the system
pressure is too low.
The pump is not running.
After the pump has been
switched on, the timer LED
does not flash and the pump
does not start up.
There is filter medium in the
pool
If the problem cannot be solved, contact the customer service listed on the last page.
Possible cause
The filter medium is dirty.
The inlet nozzle is closed.
The water flow in the
vessel is blocked because
"GESCHLOSSEN" mode is
active.
The filter balls are dirty.
The pump is sucking in air.
The water level in the pool
is too low.
The prefilter basket (if
present) is clogged.
The suction line is clogged.
The timer is set.
The external timer is set.
The pump has no power.
The pump is defective.
Quartz filter sand was
topped up.
Defective screens in the
filter vessel.
Remedy
Carry out backflushing.
Open the inlet nozzle.
Select a different mode.
Remove and wash the filter balls by
hand. Exchange the filter balls if
necessary.
Check all lines and seals for leaks.
Retighten the threaded rings.
Raise the water level in the pool.
Empty the prefilter basket.
Clean the suction line.
Check the running time on the
timer.
Check the running times on the
external timer.
Connect the pump's power plug to
the power supply. Check whether
the fuse has tripped.
Contact customer service.
Backflush the system until the
water runs clear. See section
"Backflushing".
Check the screens for damage and
replace if necessary.
63