Troubleshooting - Steinbach 040590 Bedienungsanleitung

EN

Troubleshooting

Steinbach VertriebsgmbH,
Aistingerstrasse 2, 4311 Schwertberg, Österreich
FR/IT/CZ/HU/HR/SK/SLO/RO/BG/TR: +43 (0) 7262 / 61431-0
e-mail: service@steinbach.at
www.steinbach.at
Kartuschenfilteranlage | 2015_V1
Problem Cause
No electricity
Motor does not
run
Impeller is blocked
Windings burnt out
Pump is not fully sub-
merged in water
Impeller damaged
Motor runs but
little or no water
Rotor turns in the wrong
is drawn in
direction
Motor runs in- Impeller is blocked or is
termittently permanently overloaded
Possible remedy
Check electricity
source, switch and
wiring (have them
repaired or re-
placed by profes-
sionals)
Dismantle pump
and clean
Replace pump
Raise water level
or lower pump
Clean filter insert
Switch transformer
off and then back
on again
Clean cartridge
and protect trans-
former against
overheating.
Page 5 of 30