Maintenance And Storage; Description Of Components - Sabo 47-EL VARIO Betriebsanleitung

– before you check, clean or carry out any work on the machine;
– before you eliminate jams or blockages in the ejection channel;
– when you hit a foreign body;
– if the machine starts to vibrate strangely.
• If a foreign object has been encountered or if the machine becomes blocked, e.g. by driving onto an obstacle, a
specialist dealer must check whether parts of the machine have been damaged or deformed. Any necessary repairs
must also be carried out by an authorized specialist workshop.
• If you notice unusually strong vibrations in your machine, you must have it checked by an authorized dealer.
Switch the engine off, and ensure that all moving parts have come to a complete standstill:
– if you have to lift or tilt the lawnmower, e.g. in order to transport it,
– when transporting the machine to and from the lawn
– when moving the machine off the lawn area;
– if the machine is left unattended for a few minutes;
– when adjusting the cutting height;
– before removing the collector bag.

Maintenance and storage

• Ensure that all screws have been tightened securely and that the machine is in a safe working condition.
The ejection flap must only be opened and the grass collector removed when the motor is turned off.
Always check the grass collector at regular intervals for wear and tear or loss of function.
Always check the condition and tightness of the blade prior to mowing. A worn or damaged blade must be
replaced immediately.
Always have the replacement, sharpening or balancing of the blade carried out by an authorised workshop,
since according to the applicable standard DIN EN 60335, an insulation test must always be carried out
following repairs or maintenance work to insulating components (e.g. blade screws).
• For reasons of safety, always replace worn or damaged parts.
Protective gloves must be worn at all times during maintenance and cleaning work.
Maintenance and cleaning work must only be performed when the motor has been switched off and the plug has
been pulled out of the socket.
Do not clean the machine with running water or pressure cleaners. This could damage the electrical system.
For warranty and safety reasons, original replacement parts must be used at all times.
• Notes for Switzerland:
Electric appliances must only be operated if a residual current operated device with a maximum breaking current of 30
mA is also integrated into the circuit.
• Notes for Austria:
The socket coupler of the connecting cable must be splashproof.
6

DESCRIPTION OF COMPONENTS

1 Cable connection plug
2 Variable speed switch
3 Actuating grip for motor (safety grip)
4 Bridge
5 Electric motor
6 Cutting height adjuster
7 Carrying handle front
8 Ejection flap
9 Strain relief device for electric cable
10 Cable guide
11 Drive switch operating lever
12 Locking button (red)
7
GB