Inserting And Connecting The Flight Battery - Reely Jet Gyro Bedienungsanleitung

c) Inserting and connecting the flight battery
The flight battery slot is located on the underside of the
fuselage directly behind the nose undercarriage slot (see
also Figure 4, no. 4).
Push the locking lever (1) forward and swing open the
cover (2).
Before connecting the flight battery (3), check the on/off
switch on the receiver (4). The switch must be in the "OFF"
(= switched off) position, as shown in Figure 5.
Connect the reverse polarity protected plug of the model
electronics (5) to the flight battery.
Try to arrange the flight battery as close to the front of the
slot as possible. If necessary, use a small piece of foam
to fix the flight battery in this position and close the cover.
The cover lock must securely snap into place.
Caution, important!
When the model is not in use, for example,
when it is transported or stored, always unplug
the flight battery and remove it from the slot.
The flight battery should only be connected
when you are using the model.
Figure 5
41