Reely Speedy Mania Bedienungsanleitung Seite 46

Drive function
Forward travel is controlled with the throttle trigger switch (Figure 1, no. 3). Pulling the throttle trigger switch from the
middle (neutral) position brings the propeller into rotation, with the rotational speed increasing as the switch is pulled
further. The motor runs at maximum speed when the throttle trigger switch is fully pulled towards the handle.
Pushing the throttle trigger switch back to the middle position brings the propeller back to halt.
If the propeller continues to run even when the throttle trigger switch is in the middle (neutral) position, this
can be corrected using the trim buttons "TH/TRIM" as described in section 10. h).
Steering function to the right
The steering function is controlled with the rotary wheel (Figure 1, no. 2). If you move the rotary wheel from the middle
position to the right, the dummy of the outboard motor (and the rudder located on the underside) must move to the
right as seen in the direction of travel. The model boat will then make a turn to the right.
Steering function to the left
If you move the rotary wheel from the middle position to the left, the dummy of the outboard motor (and the rudder
located on the underside) must move to the left as seen in the direction of travel. The model boat will then make a
turn to the left.
If the dummy of the outboard motor (and the rudder located on the underside) moves in a direction different
from the steering movement of the rotary wheel, the reverse switch for steering function (Figure 2, no. 6) is
in the wrong position and must be switched over.
46
Figure 7
Figure 8