Maintenance - Scheppach HS510 Originalanleitung

• Cracks due to the ageing of the insulation.
Faulty electrical connecting leads such as these may not
be used and are highly dangerous due to the insula-
tion damage.
Check electrical connecting leads regularly for damage.
Ensure that the connecting lead is not attached to the
mains supply when you are checking it.
Electrical connecting leads must correspond to the rel-
evant VDE and DIN regulations. Only use connecting
leads with the code H 07 RN. The type designation must
be printed on the connecting lead by regulation.
Single-phase motor
• The supply voltage must be 230 volt – 50 Hz.
• Extension leads up to 25 m in length must have a
cross-section of 1.5 mm2. Extension leads whose
length is over 25 m must have a cross-section of at
least 2.5 mm2.
• The mains connection is fused with a 16 A slow-
blow fuse.
Please give the following information if you have any
enquiries.
• Motor manufacturer
• Kind of current
• Machine type label data
If your are sending back the motor, always send the
complete drive unit with the switch.

Maintenance

Warning: Turn off the machine and disconnect from the
power supply before conducting maintenance work or
settings.
Store the manual close to the machine.
Keep the machine clean.
Wear goggles when cleaning the machine.
Caution: Do not clean synthetic components of the
bench using aggressive cleaning agents. We recom-
mend a mild dish washing liquid. The machine must not
get into contact with water.
• Check the saw blade regularly. Use only well-sharp-
ened, crack-free and not distorted saws. Use only
tools that comply with the European standard EN
847-1.
• Exchange immediately rocker that run out.
• Check all safety installations after each maintenance
and cleaning activities.
• Ensure that there are no tools or other materials on
or in the machine before putting it into operation.
• Remove possible sawdust blockages at the dis-
charge.
Change of saw blades Fig. 13-15
1 Unplug the unit.
2 Wait until the blade stops rotating and the motor has
cooled down.
27