Remaining Hazards - Scheppach HS510 Originalanleitung

• The Scheppach machine may only be used, main-
tained, and operated by persons familiar with it and
instructed in its operation and procedures. Arbitrary
alterations to the machine release the manufacturer
from all responsibility for any resulting damages.
• The Scheppach machine may only be used with
original accessories and original tools made by the
manufacturer.
• Any other use exceeds authorization. The manufac-
turer is not responsible for any damages resulting
from unauthorized use; risk is the sole responsibility
of the operator.Remaining hazards.
m Remaining hazards
The machine has been built using modern technol-
ogy in accordance with recognized safety rules.
Some remaining hazards, however, may still exist.
• The rotating saw blade can cause injuries to fingers
and hands if the work piece is incorrectly fed.
• Thrown work pieces can lead to injury if the work
piece is not properly secured or fed.
• Noise can be a health hazard. The permitted noise
level is exceeded when working. Be sure to wear
personal protective gear such as ear protection.
• Defective saw blades can cause injuries. Regularly
inspect the structural integrity of saw blades.
• The use of incorrect or damaged mains cables can
lead to injuries caused by electricity.
• The operating instructions supplied with the special
accessories must be observed and carefully read
when Scheppach special accessories are used.
• Even when all safety measures are taken, some re-
maining hazards which are not yet evident may still
be present.
• Remaining hazards can be minimized by following
the instructions in "Safety Precautions", "Proper Use"
and in the entire operating manual.
Equipment, Fig. 1 and 2
1 Motor with frame
2 rocker
3 Inner saw blade
cover
4 Outer saw blade
cover
5 Saw blade
protection, front
6 Saw blade
protection, bottom
7 Rocker holder
8 Stand base
9 Mounting hole
10 Cross brace
11 Retaining spring
12 handle bar
13 Rocker inlet
14 Moving gear
15 Adjustment screw
rocker extension
16 Plug combination/
ON/OFF-Button
17 Motor board
18 Guard panel
19 Rocker extension
20 Locking lever
21 Adjustment screw
rocker fence
19