Scheppach HS510 Originalanleitung Seite 29

3 Bring the jack into the transport position and lock the
saw in this position with the locking lever.
4 Remove the hex nut (A) and the recoil spring (B).
5 Loosen the locking lever and grasp the jack firmly so
that it does not fall down and the recoil spring cannot
jump out of the unit in an uncontrolled fashion.
6 Tip the jack carefully back and place it on the ground.
7 Take the key (fig. 13, right side) in order to stopback
the flange, use the saw blade key (fig. 13, left side)
to open the hex nut and remove the flange.
8 Carefully remove the saw blade. Wear protective
gloves for this part of the work. (Attention: there is
danger of injury, so please take caution!)
9 Before replacing the saw flange, clean the flange with
a cloth or soft brush.
10 Replace the saw blade and flange and tighten the
flange nut.
11 Make sure the jack with the spring coil is properly
placed and tighten the hex nut once again properly.
12 Test the functionality of the rocker.
ATTENTION ! Observe the correct direction of rotation
when inserting the saw blade.
Adjustment of the jack stop, Fig.16
Set the entry point of the jack with the adjustment screw.
29