Scheppach HS510 Originalanleitung Seite 13

• Faulty saw blades must be replaced immediately.
• Never use saw blades which do not comply with the
data specified in this manual.
• Never dismantle the machineʼs safety devices or
render them inoperative.
• If the table insert is worn, replace it.
• Always stand to the side of the saw blade when work-
ing with the saw.
• Never load the machine so much that it cuts out.
• Make sure that off-cuts do not catch on the saw blade
crown. Risk of catapulting!
• Never remove loose splinters, chips or jammed piec-
es of wood when the saw blade is running, unless a
push stick is used.
• To rectify faults or remove jammed pieces of wood,
always switch off the machine first. Pull the power
plug!
• If the sawing gap is worn, replace the table insert.
Pull the power plug!
• Carry out retooling work, adjustments, measure-
ments and cleaning jobs only when the motor is
switched off. Pull the power plug!
• Before switching on, make sure that all keys and
wrenches have been removed from the tool.
• Switch off the motor and pull the power plug before
you leave the workplace.
• Refit all guards and safety devices immediately af-
ter you have completed any repairs or maintenance
work.
• Be sure to observe the safety information and op-
erating and maintenance instructions issued by the
manufacturer, as well as the dimensions listed in the
Technical Data.
• It is imperative to observe the accident prevention
regulations in force in your area as well as all other
generally recognized rules of safety.
• Note the information published by your professional
associations (VBG 7j).
• The circular saw has to be connected to a 230 V
socket with a 16 A fuse.
• Do not use any low-powered machines for heavy
duty work.
• Do not use the cable for purposes for which it is not
designed.
• Make sure you stand squarely and keep your bal-
ance at all times.
• Check the tool for damage.
• Each time before re-using the tool, carefully check
that the guards or any slightly damaged parts are
working as intended.
• Check that the moving parts are in good working
order, that they do not jam, and that no parts are
damaged. Make sure that all parts are fitted correctly
and that all other operating conditions are properly
fulfilled.
• Unless otherwise stated in the operating instructions,
damaged safety devices and parts must be repaired
or replaced by an authorized service center.
• Have damaged switches replaced by a customer
service workshop.
• This electric tool complies with the pertinent safety
13