Operation; Hydraulic Connection; Transport Directions - Gude DHH 1050/7 T ECO Bedienungsanleitung

Operation

1. At low temperatures, have the machine idling for about 15 minutes for the oil to get warmed to the required
temperature.
2. Lay a piece of wood to be cleaved on the table and hold it to the lever using anchoring wires/grabs.
3. Start cleaving pushing both the levers downward.
4. With cleaving completed, lift one lever at least, the cleaving column will go up automatically.
It is strictly forbidden for two persons operate the machine at a time, when one would hold the wood and the
other one would operate the wires/grabs. Never block the lever (anchoring wire/grab).
Stroke adjustment
With pieces up to ca 50 cm long or a bigger quantity, it is possible to
increase the working capacity by making the cleaving knives reverse
shorter.
Model DHH 1050/6TC with control rod
Procedure is as follows:
Lay a short piece of wood on the table, lower the knife down to be at a
distance of ca 2 cm above the piece and put the machine off (push red
button on the switch and unplug). Now, you may adjust the reverse run
using the side rod fixing the rod at a required height with an adjusting
screw.

Hydraulic Connection

Hydraulic hoses and joints shall be checked for leakage every 4 hours of operation
and retightened if necessary.
Hydraulic oil/tank
Common hydraulic oil may be replenished in all cleaving machines (HLP 46 e.g.)
or another product of the same viscosity. Oil change is not necessary .
Type DHH 1050/ 7 T/ MBS: tank ca 6 litres

Transport Directions

Transport
All cleaving machines have large wheels. To move the machine, hold the cleaving column lug with one hand and the lug
above the motor with the other hand and tip the machine slightly over to your body. Once in this position, the machine
may travel easily.
Never transport the cleaving machine in horizontal position to prevent
any leakage of fuel and hydraulic oil.
For transport, move the cleaving knife down completely.
Lärminformation
Type DHH 1050/7 T ECO/ idle run ca 67 dbA = full load ca 86 dbA
18