2
2.
Insert the hold-in stud through
in front of the cross member.
3
Cleaving Cross Assembly
1
4
2a
3.
Adjust the grabs to correspond to the wood piece diameter.
4
6.
Screw the holding screw in the cross up to the half .
2
3.
Fit the cleaving cross on a screw the
holding screw in the knife
recess until the nut fits on tightly.
4.
Adjust the screw and the nut for
the cleaving cross to get pushed
completely up.
15
4. Secure the hold-in stud bottom with a
cotter pin included in the delivery.
2. Screw on the nut included from
outside.
3