Area Of Use - Gude DHH 1050/7 T ECO Bedienungsanleitung

Open the fuel tap
Put the engine switch to the "ON" position (pic. 3)
Make sure the engine is cold when being started.
Turn on the engine choke (pic. 4; pos. "CHOKE")
Turn the speed control lever (pic. 4; pos. "START") to full speed.
First, pull shortly the starting cable so that it is stretched. Now pull the starting cable slowly to the stretched
position with your left hand resting on the engine and one more strong pulling the starting cable. Turn the
engine choke off as soon as the engine gets started (pic. 4; pos. "RUN")
Give full throttle using the speed control lever (pic. 4; pos."HARE")
To be provided
The starting cable must not reel automatically. It must always be reeled back by hand. If the engine fails to
start even after several attempts, check whether the tank has been refuelled properly. Maybe there is too
much fuel in the roll, which has caused the spark plug to get damp.
Switching off the engine
Put the speed control level to the idle gas position (pic. 4; pos. Želva).
Use the engine switch (pic. 3; pos. "OFF") to switch off the engine. Never leave the appliance unattended
when the engine is running. Never switch the engine off when the choke is on as the engine could get
damaged. Close the fuel tap (pic. 2; pos. "OFF"). Pull slowly the starter handle until you feel resistance. By
this, valves get closed.
This step is necessary to prevent moist air from entering the combustion chamber from outside.
1. Put the wood to be split on the table as short or long logs and set the backward movement accordingly
(see Lift setting).
2. Now clasp the split wood with both operating arms (see Stop screw setting) and press them down at the
same time.
3. Remove the split wood from the working area and put another wood on the table.
4. If the splitting knife is greased from time to time, more difficult wood can also be split.
Start the splitter and wait until the splitting column gets to the starting position.
Now press both operating levers to make the splitting column go down. Press just the right or left operating
lever in turn. If the splitting column stands each time, you can use the splitter with no worry.
.
If the splitting column keeps going down, the two-hand operation must be subject to new calibration.
For that purpose, contact an authorised workshop.
V nebezpečných situacích a při nehodách musíte dát páku pro regulaci otáček co možná nejrychleji
do polohy „STOP" a motor vypnout spínačem motoru (obr. 3; poz. „OFF").

Area of Use

The machine is approved for wood processing only. The material to be cleaved shall be of dimensions as follows:
Minimum diameter: 120 mm
-
Maximum diameter: 300 mm
Wood is permitted to be cleaved in the direction of grain only.
-
There is a risk of jamming of branchy wood while being cleaved.
-
The jammed pieces may be knocked/banged out.
-
Never cut it out!
-
Cleaving Length Set-up
Various length of wood pieces may be cleaved:
Type DHH 1050/6 TC
Cleaving length ca 1050/810/560 mm.
17