Eu Declaration Of Conformity; Troubleshooting - Gude BASIC 10T/DTS Originalbetriebsanleitung

EU Declaration of Conformity

We,
Güde GmbH & Co. KG
Birkichstraße 6
74549 Wolpertshausen
Germany
herewith declare that the following appliance complies with the appropriate basic safety and health requirements of the EU
Directives based on its design and type, as brought into circulation by us.
In case of alternation of the machine, not agreed upon by us, this declaration will lose its validity.
Machine description:
Article No.
Date/authorised signature:
Title of signatory:
Technical documentation:
Applicable EU Directives:
2004/108/EG
2006/42/EG
Applicable harmonised standards:
EN 609-1/A2:2009
EN 61000-3-3:1995+A1+A2
EN 61000-3-2:2006
EN 55014-2:1997+A1
EN 55014-1:2006
Noise:
Lwa: 85,2 dB
Lpa: 69,9 dB

Troubleshooting

Problems
Engine not starting
Wrong engine running
direction
Splitting knife not moving
Splitter has no power
After being pressed, the
green switching button not
staying in place
Hydraulic pump whistling;
splitting knife running jerky
Basic 10T/DTS log splitter
02040
07.03.2012
Managing Director, Mr Arnold
J. Bürkle FBL; QS
Possible causes
1. No current in the outlet
2. Defective extension cable
3. Wrong feeder cable
4. Defective switch, condenser
1. Wrong connection
1. Two-hand switching lever adjustment
1. Wrong rotation direction
2. Too little hydraulic oil
3. Starting rod is bent; the hydraulic
lifter is not pressed to the full extent
4. Wood with too many knots - splitting
knife gets jammed
5. Operating arm is bent
1. Defective fuse, etc.
2. 2 phase running
1. Oil loss, surface is dirty
2. Too little hydraulic oil in the tank
Remedy
1. Check the network protection
2. Pull out the plug – check it and replace it if
necessary
3. Connection with 5 cores with a cross section of
2
2.5 mm
4. Have the appliance checked by an electrician
1. Turn the phase changer in the appliance plug
using a screwdriver
1.  Check the oil level
 Defective control valve must be replaced in a
service centre only
1. Change the rotation direction
2. Add hydraulic oil
3.  Check all screws on the starting rod
mechanism
 Adjust the pull rod (pic. 10/B); by this,
 the hydraulic lifter will be pressed to the full
extent.
4. Lubricate the splitting knife with fat.
5. Return the operating arm to the starting position.
1. Check the cable
1.  Tighten the screwing
 Replace the hoses
2. Add hydraulic oil