B. Braun Aesculap Spine TSPACE PEEK Gebrauchsanweisung/Technische Beschreibung Seite 18

Aesculap ®
TSPACE PEEK/TSPACE
Mechanical cleaning/disinfection with manual pre-cleaning
Note
The cleaning and disinfection device must be of tested
and approved effectiveness (e.g. FDA approval or CE
mark according to DIN EN ISO 15883).
Manual pre-cleaning with a brush
Phase Step
I Disinfec-
tant
cleaning
II Rinsing
D–W: Drinking water
RT: Room temperature
*Recommended: BBraun Stabimed
►
Note the information on appropriate cleaning
brushes and disposable syringes, see Validated
cleaning and disinfection procedure.
Phase I
►
Fully immerse the product in the cleaning/disinfec-
tant for at least 15 min. Ensure that all accessible
surfaces are moistened.
►
Clean the product with a suitable cleaning brush in
the solution until all discernible residues have been
removed from the surface.
►
If applicable, brush through non-visible surfaces
with an appropriate cleaning brush for at least
1 min.
►
Mobilize non-rigid components, such as set screws,
links, etc. during cleaning.
►
Thoroughly rinse through these components with
the cleaning disinfectant solution (at least five
times), using a disposable syringe.
16
XP
instruments
T t
[°C/°F] [min]
RT (cold) >15
RT (cold) 1
Note
The cleaning and disinfection device used for process-
ing must be serviced and checked at regular intervals.
Conc. Water
[%] quality
2 D–W
- D–W
Phase II
►
Rinse/flush the product thoroughly (all accessible
surfaces) under running water.
►
Mobilize non-rigid components, such as set screws,
joints, etc. during rinsing.
Chemical
Aldehyde-free, phenol-free, and
QUAT-free concentrate, pH ~ 9*
-