Meec tools 016640 Bedienungsanleitung Seite 52

The correct power tool will work better
and more safely when used with the load
for which it was designed.
• Do not use the power tool if it cannot be
switched on and off with the power
switch.
• Power tools that cannot be controlled
with the power switch are dangerous and
must be repaired.
• Unplug the plug from the mains and/or
remove the battery from the power tool
before making any adjustments, replacing
accessories or putting the tool away.
• These safety precautions reduce the risk of
accidentally starting the power tool.
• Store power tools out of the reach of
children when not in use. Never allow
anyone who is unfamiliar with the power
tool and these instructions to use the tool.
Power tools are dangerous in the hands of
inexperienced users.
• Keep the power tool properly maintained.
Check that moving parts are not
misaligned, jammed or loose, and that
there are no other factors that could affect
the safe use of the tool. If the power tool
is damaged, it must be repaired before
being used again. Many accidents are
caused by poorly maintained power tools.
• Make sure that cutting tools are sharp and
clean. Properly maintained cutting tools
with sharp cutting edges are less likely to
jam and are easier to control.
• Use the power tool, accessories and bits
etc., in accordance with these instructions,
taking into account the actual working
conditions and the work that is to be
done. Using the power tool for anything
other than its intended purpose can lead
to dangerous situations.
SERVICE
Make sure that the power tool is serviced by
qualified technicians that only use identical
spare parts. This will ensure that the power tool
remains safe to use.
SAFETY INSTRUCTIONS
FOR DRILLING
• Use ear protection for percussion drilling.
Exposure to loud noise can cause hearing
impairment.
• Use the support handles, where
appropriate. Losing control of the power
tool can result in personal injury.
• Hold the power tool by the insulated grips
when working in areas where the drill can
come into contact with concealed
electrical cables or its own power cord.
When cutting accessories come into
contact with a live wire, unprotected metal
parts on the tool may become charged
and give the user an electric shock.
VIBRATION AND NOISE
ATTENUATION
• To reduce the effects of noise and
vibrations you should limit the time in
use, use the low-vibration and low-noise
modes, and wear personal safety
equipment.
• Observe the following to minimise the risk
of exposure to vibrations and loud noise:
– Only use the product for the purpose
it was designed for and according to
these instructions.
– Make sure that the product is in good
condition and well maintained.
– Use the right accessories for the
product and make sure they are in
good condition.
– Keep a firm grip on the handles/
gripping surface.
– Maintain the product according to
these instructions and ensure that it
is well lubricated (where applicable).
– Plan the work schedule to spread the
use of tools with strong vibrations
over a longer period.
EN
51