Replacing The Lamp; Troubleshooting - Electrolux EOB6640AAX Benutzerinformation

the above steps in the opposite
sequence.
Make sure that you put the glass panels
(A and B) back in the correct sequence.
The first panel (A) has a decorative
frame. The screen-printing zone must
face the inner side of the door. Make
sure that after the installation the surface
of the glass panel frame (A) on the
screen-printing zones is not rough when
you touch it.
A
Make sure that you install the middle
panel of glass in the seats correctly.

11. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
11.1 What to do if...
Problem
You cannot activate or op‐
erate the oven.
All manuals and user guides at all-guides.com
B
A
B
Possible cause
The oven is not connected
to an electrical supply or it
is connected incorrectly.

10.8 Replacing the lamp

Put a cloth on the bottom of the interior
of the appliance. It prevents damage to
the lamp glass cover and the cavity.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp.
The lamp and the lamp glass
cover can be hot.
CAUTION!
Always hold the halogen
lamp with a cloth to prevent
grease residue from burning
on the lamp.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box
or deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.
Remedy
Check if the oven is cor‐
rectly connected to the
electrical supply (refer to
the connection diagram if
available).
ENGLISH 33