Replacing The Lamp; Troubleshooting - Electrolux EOB2430AOX Benutzerinformation

20 www.electrolux.com
4. Put the door on a soft cloth on a
5. Hold the door trim (B) on the top
6. Pull the door trim to the front to
7. Hold the door glass panel by its top
8. Clean the glass panel with water and
When the cleaning is completed, install
the glass panel and the oven door. Do

11. TROUBLESHOOTING

Downloaded from www.Manualslib.com
stable surface.
edge of the door at the two sides and
push inwards to release the clip seal.
2
B
1
remove it.
edge and carefully pull it out. Make
sure the glass slides out of the
supports completely.
soap. Dry the glass panel carefully.
WARNING!
Refer to Safety chapters.
manuals search engine
the above steps in the opposite
sequence.
The screen-printing zone must face the
inner side of the door. Make sure that
after the installation the surface of the
glass panel frame on the screen-printing
zones is not rough when you touch it.
Make sure that you install the internal
glass panel in the seats correctly.

10.7 Replacing the lamp

Put a cloth on the bottom of the interior
of the appliance. It prevents damage to
the lamp glass cover and the cavity.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp.
The lamp and the lamp glass
cover can be hot.
CAUTION!
Always hold the halogen
lamp with a cloth to prevent
grease residue from burning
on the lamp.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box
or deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.
A