Replacing The Lamp; Troubleshooting - Electrolux EOB5454TAX Benutzerinformation

26 www.electrolux.com
7. Put the door on a soft cloth on a
8. Hold the door trim (B) on the top
9. Pull the door trim to the front to
10. Hold the door glass panel by its top
11. Clean the glass panel with water and

11. TROUBLESHOOTING

Downloaded from www.Manualslib.com
stable surface.
edge of the door at the two sides and
push inwards to release the clip seal.
2
B
1
remove it.
edge and carefully pull it out. Make
sure the glass slides out of the
supports completely.
soap. Dry the glass panel carefully.
WARNING!
Refer to Safety chapters.
manuals search engine
When the cleaning is completed, install
the glass panel and the oven door. Do
the above steps in the opposite
sequence.
The screen-printing zone must face the
inner side of the door. Make sure that
after the installation the surface of the
glass panel frame on the screen-printing
zones is not rough when you touch it.
Make sure that you install the internal
glass panel in the seats correctly.

10.8 Replacing the lamp

WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
cavity.
CAUTION!
Always hold the halogen
lamp with a cloth to prevent
grease residue from burning
on the lamp.
The back lamp
1. Turn the lamp glass cover to remove
it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.
A