Cleaning The Water Tank - Electrolux EOB6640AAX Benutzerinformation

30 www.electrolux.com
damaged. Contact an Authorised
Service Centre.
• To clean the door gasket, refer to the
general information about cleaning.
10.4 Removing the shelf
supports
To clean the oven, remove the shelf
supports.
1. Pull the front of the shelf support
away from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
1
Install the shelf supports in the opposite
sequence.
10.5 Aqua Cleaning
The Aqua cleaning procedure uses
steam to help remove remaining fat and
food particles from the oven.
1. Put 300 ml of water into the Aqua
cleaning container at the bottom of
the oven.
2. Set the function
3. Set the temperature to 90 °C.
4. Let the appliance operate for 30
minutes.
All manuals and user guides at all-guides.com
2
.
5. Deactivate the appliance and let it
cool down.
6. When the appliance is cool, clean the
inside of the oven with a soft cloth.
WARNING!
Make sure that the
appliance is cool before
you touch it. There is a
risk of burns.

10.6 Cleaning the water tank

WARNING!
Do not put water into the
water tank during the
cleaning procedure.
During the cleaning
procedure, some water can
drip from the steam inlet
onto the cavity of the oven.
Put a dripping pan on the
shelf level directly below the
steam inlet to prevent water
from falling onto the bottom
of the oven cavity.
After some time, you can have lime
deposits in your oven. To prevent this,
clean the parts of the oven that generate
the steam. Empty the tank after each
steam cooking.
Types of water
• Soft water with low lime content -
the manufacturer recommends this
because it decreases the quantity of
cleaning procedures.
• Tap water - you can use it if your
domestic water supply has purifier or
water sweetener.
• Hard water with high lime content -
it does not have an effect on the
performance of the appliance but it
increases the quantity of cleaning
procedures.