Replacing The Lamp; Troubleshooting - Electrolux ROB2200AON Benutzerinformation

after the installation the surface of the
glass panel frame on the screen-printing
zones is not rough when you touch it.
Make sure that you install the internal
glass panel in the seats correctly.

10.6 Replacing the lamp

Put a cloth on the bottom of the interior
of the appliance. It prevents damage to
the lamp glass cover and the cavity.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp.
The lamp and the lamp glass
cover can be hot.

11. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
11.1 What to do if...
Problem
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
The lamp does not oper‐
ate.
Steam and condensation
settle on the food and in
the cavity of the oven.
A
1. Deactivate the appliance.
2. Remove the fuses from the fuse box
The back lamp
1. Turn the lamp glass cover
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
4. Install the glass cover.
Possible cause
The oven is deactivated.
The Minute Minder + End
of Cooking programmer is
not set.
The fuse is blown.
The lamp is defective.
You left the dish in the
oven for too long.
CAUTION!
Always hold the halogen
lamp with a cloth to prevent
grease residue from burning
on the lamp.
or deactivate the circuit breaker.
counterclockwise to remove it.
°C heat-resistant lamp.
Remedy
Activate the oven.
Set the Minute Minder +
End of Cooking program‐
mer. Refer to the chapter
"Clock functions".
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Replace the lamp.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the
cooking process ends.
ENGLISH 17