Working Instructions; Checking The Air Pressure; Overload Fuse; Valve Adapters - ULTIMATE SPEED UMK 10 C2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Removing the connetion valve:
Connecting without valve adapter
ing lever for the connection valve
8
from the valve of the inflatable.
Connecting with valve adapter
adapter from the valve of the inflatable. Open the clamp-
ing lever of the connection valve
8

valve adapter

.
10
Note: Air may escape from the valve of the inflatable when
removing the connection valve
the connection valve too quickly.
7
The manometer is not calibrated. Therefore seek a
2
specialist facility with a calibrated device after inflating
inflatables where incorrect pressure can be dangerous
(e.g. car tyre).

Working instructions

This product is not suitable for continuous operation. It was
developed to produce air pressure, not air volume.
16 GB
: Open the clamp-
10
and remove
7
: Remove the valve
10
and remove the
7
. Be sure not to remove
7
Do not use the product for longer than 5 minutes without
interruption to prevent overheating and damage to the
device. Afterwards allow to cool for a minimum of
20 minutes.

Checking the air pressure

Note: The device does not need to be connected to the
cigarette lighter to test air pressure.
Connect the connection valve
Read the air pressure on the display of the manometer
Remove the connection valve
use").
Note: The manometer
Attention: Please use a calibrated gauge if user needs an
accurate measurement.

Overload fuse

In the event of overuse or malfunction the overload fuse
in the cigarette lighter plug
(see "Initial use").
7
once more (see "Initial
7
is not calibrated.
2
will trip to protect the device.
5
.
2
11