Operation; Working Instructions; Checking The Air Pressure; Overload Fuse - ULTIMATE SPEED UMK 10 C2 Bedienungs- Und Sicherheitshinweise

Operation

Working instructions

This product is not suitable for continuous operation. It was
developed to produce air pressure, not air volume.
Do not use the product for longer than 5 minutes without
interruption to prevent overheating and damage to the
device. Afterwards allow to cool for a minimum of
20 minutes.

Checking the air pressure

Note: The device does not need to be connected to the
cigarette lighter to test air pressure.
Connect the connection valve
Read the air pressure on the display of the manometer
Remove the connection valve
use").
Note: The manometer
Attention: Please use a calibrated gauge if user needs an
accurate measurement.
(see "Initial use").
7
once more (see "Initial
7
is not calibrated.
2

Overload fuse

In the event of overuse or malfunction the overload fuse
in the cigarette lighter plug
Replace the fuse after resolving the reason for the fuse tripping
(see Fig. D).
Unscrew the tip of the cigarette lighter plug
remove the overload fuse
Insert the new overload fuse
cigarette lighter plug
Never use a fuse with a higher tripping current. Other-
wise, this poses a fire hazard!

Cleaning

. Never immerse the product in water or spray it with water.
2
Risk of injury due to electric shock if moisture enters the
device. Risk of injury due to electric shock if moisture
enters the device.
Do not use cleaners or solvents. These could damage
the product beyond repair.
will trip to protect the device.
5
and
5
.
11
and screw the tip of the
11
back on.
5
GB/CY
11
13