Initial Use; Operation; Working Instructions; Cigarette Lighter Plug - ULTIMATE SPEED UMK 10 C2 Bedienungs- Und Sicherheitshinweise Und Originalbetriebsanleitung

Dispose of the device if the
cable is damaged.

Initial use

Place the product on a level, non-flammable
surface. Do not cover the vents. Do not operate
the device in dusty environments. Doing so
poses a fire hazard and could damage the de-
vice.
For inflatables with counterpressure (e.g. partly
filled car tyre): Switch on the product before
connecting the connection valve
Note: Depending on the inflatable you can
use the connection valve
with the included valve adapter
Connecting to the cigarette lighter socket:
Note: Verify the socket of the cigarette lighter in
your vehicle has an adequately sized fuse.
Verify the product is switched off: on / off switch
to position „0".
6
Plug the cigarette lighter plug
of the 12 V cigarette lighter.
Connecting the connection valve
Open the connection valve
lever vertical (see Fig. B).
8
Connecting without valve adapter
- Insert the open connection valve
valve of the inflatable (if necessary, first remove
valve cover of the inflatable).
- Hold the connection valve and close: push
tensioning lever
8
Connecting with valve adapter
- Push the respective valve adapter into the
opening in the connection valve
- Secure the valve adapter into the connection
valve : push clamping lever
7
connection valve (see Fig. C).
- Insert the valve adapter
the inflatable (if necessary, first remove valve
cover of the inflatable).
to the tyre.
7
directly or along
7
(see Fig. A).
10
into the socket
5
:
7
: clamping
7
:
10
into the
7
toward connection valve
:
10
.
7
toward
8
into the valve on
10
Switching on / off:
Switch the device on: on / off switch
position „I".
Once the desired filling pressure has been
reached, switch the device off: on / off switch
to position „0".
6
Remove the cigarette lighter plug
Removing the connetion valve:
Connecting without valve adapter
the clamping lever
and remove from the valve of the
7
inflatable.
Connecting with valve adapter
valve adapter from the valve of the inflatable.
Open the clamping lever
valve and remove the valve adapter
7
Note: Air may escape from the valve of the inflat-
able when removing the connection valve
sure not to remove the connection valve
quickly.
The manometer
seek a specialist facility with a calibrated de-
vice after inflating inflatables where incorrect
pressure can be dangerous (e.g. car tyre).

Operation

Working instructions

This product is not suitable for continuous operation.
It was developed to produce air pressure, not air
. volume.
7
Do not use the product for longer than 5 minutes
without interruption to prevent overheating and
damage to the device. Afterwards allow to
cool for a minimum of 20 minutes.
to
6
.
5
: Open
10
for the connection valve
8
: Remove the
10
of the connection
8
7
too
7
is not calibrated. Therefore
2
.
10
. Be
GB 9