Intended Use - VOLTCRAFT 1090519 Bedienungsanleitung

3. Intended use

- Measurement and display of the electrical values in the range of measurement category CAT III (up to 250 V
against earth potential according to EN 61010-1) and all lower categories. The measuring device must not be used
in the CAT IV measurement category.
- Measurement of direct and alternating voltages up to 250 V
- Measurement of direct current up to 10 A
- Measurement of resistance values of up to 20 MOhm.
- Acoustic continuity check
- Diode tests
- Non-contact 230 V/AC voltage test
- hFE transistor test (only with optional measuring adapter)
The two current measurement inputs are protected against overload. The voltage in the measuring circuit may not
exceed 250 V. The measuring ranges are equipped with ceramic high-performance fuses.
Only use batteries of the specified type.
The measuring device must not be used when it is open, with an open battery compartment or when the battery com-
partment cover is missing. Measurements must not be made in damp rooms or in adverse environmental conditions.
For safety reasons, only use measuring leads or accessories that match the device specifications.
Unfavourable ambient conditions include:
- Wetness or high air humidity,
- Dust, flammable gases, vapours or solvents,
- Thunderstorms or similar conditions such as strong electrostatic fields, etc.
Using this product for purposes other than those described above may damage the product and result in short circuit,
fire or electric shock. The product must not be modified or reassembled!
Read the operating instructions carefully and keep them in a safe place for future reference.
Always observe the safety information in these instructions.
24