Intended Use - VOLTCRAFT VC-22 Bedienungsanleitung

3. Intended use

• Measurement and display of the electrical quantities in the range of measurement category
CAT III (up to 600 V against earth potential according to EN 61010-1) and all lower catego-
ries. The measuring device must not be used in the CAT IV measurement category.
• Measurement of direct and alternating voltage up to 600 V
• Measurement of resistance values of up to 20 MOhm.
• Acoustic continuity test
• Non-contact 230 V/AC voltage test
• Temperature measurement from -40 to +300 °C / 572 °F
Only use batteries of the specified type.
The measuring device must not be used when it is open, with an open battery compartment
or when the battery compartment cover is missing. Measurements must not be made in damp
rooms or in adverse environmental conditions.
For safety reasons, only use test leads or accessories that match the multimeter's specifications.
Adverse conditions include:
• Wetness or high air humidity,
• Dust and flammable gases, vapours or solvent,
• Thunderstorms or similar conditions such as strong electrostatic fields, etc.
Using this product for purposes other than those described above may damage the product and
result in a short circuit, fire or electric shock. The product must not be modified or reassembled!
Read the operating instructions carefully and keep them in a safe place for future reference.
Always observe the safety information in these instructions.
24