Installation; Electrical Connection - Balluff BTL BNC 00 B15A 010-000S92 Serie Betriebsanleitung

BTL BNC_ 00- _ _ _ _ -B15A _010-000S92 / BTL ZNC_ 00- _ _ _ _ -B15A _010-000S92
Magnetostrictive Linear Position Sensor – Rod Style
5
Installation and connection (continued)
5.2

Installation

For dimensions, see Fig. 4-1 on page 7.
Suitable nuts for the mounting thread are
available as accessories (see page 17).
NOTICE
Interference in function
Improper installation can compromise the function of the
BTL and result in increased wear.
► Ensure that the contact surface of the BTL is in full
contact with the mounting surface.
► Seal the hole perfectly (O-ring/flat seal).
Mounting in a hole with internal thread (mounting
hole)
1. Make a mounting hole with thread (possibly with
countersink for the O-ring) acc. to Fig. 5-3 or Fig. 5-4.
2. Screw the BTL with mounting thread into the mounting
hole (max. torque 75 Nm).
Mounting in a through-hole
1. Guide the BTL through the hole.
2. Screw the mounting nut (max. torque 75 Nm, see
Accessories on page 17) onto the mounting thread
on the rod side.
Further steps
► Install the magnet (accessory).
► From 500 mm measuring length: Support the rod and,
if necessary, screw it on at the end (with threaded rod
end).
10 english
5.3

Electrical Connection

The electrical connection is made via a plug connection
(for pin assignment see Tab. 5-2).
See the information about Shielding and cable
routing on page 11.
2
5
1
3
4
Fig. 5-8: Pin assignment of S92 (view from above on BTL)
Pin ...-B15AA... ...-B15A1... ...-B15AE... ...-B15A5...
1 10...30 V
2 0...10 V 10...0 V
3
4 Unassigned
5
Reference potential for supply voltage and EMC-GND.
1)
2) Unassigned leads that are not used can be connected to the GND on
the controller side but not to the shield.
Tab. 5-2: Pin assignment S92
4...20 mA 20...4 mA
GND
1)
2)
0 V