Construction And Function; Construction - Balluff BTL7-P511-M Serie Betriebsanleitung

BTL7-P511-M _ _ _ _ -T _ 2/3-S32/KA _ _ /FA _ _
Magnetostrictive Linear Position Sensor – Rod Style
3

Construction and function

BTL7-TB/TZ-Cable BTL7-TB/TZ-S32
Ø max. 7
~20
12.5
BTL7-TT-Cable BTL7-TT-S32
1) Unusable area
2) Not included in scope of delivery
3) Ø 6.1 for hook spanner Ø 74
Fig. 3-1: BTL7-..., Construction and function
3.1

Construction

Electrical connection: The electrical connection is made
via a cable or a connector ( see Type code breakdown on
page 20).
Housing: Aluminum housing containing the processing
electronics.
Fastening: We recommend assembling the following
BTLs on the mounting thread:
– BTL7-...-TB: M18×1.5
– BTL7-...-TZ: 3/4"-16UNF
– BTL7-...-TT: M30×1.5
The BTL has an additional thread at the end of the rod to
support larger nominal lengths.
www.balluff.com
Mounting surface
TB: 30-1 mm
TZ: 2"-0.04"
1)
Magnet
3)
Thread size:
TB: M18×1.5
TZ: 3/4"-16UNF
0.5 Ø 30
~80 25
Mounting surface
TT: 30-1 mm
Magnet
1)
BTL-P-1028-15R 2)
Thread size:
0.5 Ø 60
TT: M30×1.5
~80 25
Damping zone
Nominal length =
60
Measuring range
2)
Permissible center offset
Magnet to rod:
±1.5 mm
Top view of the T_2-S32,
with dummy plug
Magnet: Defines the position to be measured on the
waveguide. Magnets are available in various models and
must be ordered separately (see Accessories on
page 18).
Nominal length: Defines the travel/length range available.
Rods with various nominal stroke lengths from 25 mm to
7620 mm are available depending on the version of the
BTL:
– Ø 10.2 mm: Nominal length from 25 mm to 7620 mm
– Ø 21 mm: Nominal length from 25 mm to 3250 mm
Damping zone: Area at the end of the rod that cannot be
used for measurements, but which may be passed over.
1)
TB3/TZ3
LED
Ø 74
TT3
Ø 100
english 7