Faults - WIKA GDM-RC-100-T Betriebsanleitung

5. Commissioning, operation / 6. Faults
5.7.5 Pin assignment, integrated, analogue transmitter (model GD-20-A)
Via 4-pin terminal in the cable socket, conductor cross-section 0.205 ... 2.5 mm
2-wire terminal in cable socket
U
+
U
-
A
B
5.7.6 Requirement for shield and grounding
The gas density sensor must be shielded and grounded in accordance with the ground-
ing concept of the plant.
5.7.7 Connecting the instrument
1. Assemble the mating connector or cable outlet.
→ Pin assignments, see the following chapters
5.4.2 "Pin assignment of attached, digital transmitter (model GD-20-D)"
5.4.3 "Pin assignment, integrated, digital transmitter (model GD-20-D)"
5.7.3 "Pin assignment of attached, analogue transmitter (model GD-20-A)"
5.7.4 "Pin assignment of attached, analogue transmitter with cable outlet (model
GD-20-A)"
5.7.5 "Pin assignment, integrated, analogue transmitter (model GD-20-A)"
2. Establish the plug connection.

6. Faults

CAUTION!
Physical injuries and damage to property and the environment
If faults cannot be eliminated by means of the listed measures, the gas
density monitor must be taken out of operation immediately.
▶
Ensure that pressure or signal is no longer present and protect against
accidental commissioning.
▶
Contact the manufacturer.
▶
If a return is needed, please follow the instructions given in chapter 9.2
"Return".
For contact details, see chapter 9 "Specifications" or the back page of the
operating instructions.
WIKA operating instructions, model GDM-RC-100-T
DC 10 ... 30 V
Ground
Do not use
Do not use
2
EN
31