Inhaltsverzeichnis
Werbung
STATIC ALIGNMENT
For optimal function, balance the patient's weight evenly between the heel and toe (Figure 4).
▪ Each size group has a different heel rise: 13-15 cm: 0.23 in (5.8 mm), 16-18 cm: 0.25 in (6.4 mm), 19-22 cm: 0.38 in (9.5 mm)
▪ The load line divides the foot at 1/3 heel lever and 2/3 toe lever.
DYNAMIC ADJUSTMENTS
DESIRED RESULT ALIGNMENT CHANGE
Firmer Toe Response
Softer Toe Response
Firmer Heel Response
Softer Heel Response
*To install or remove heel wedge, refer to the Scout Heel Wedge Kit Instructions.
USE IN WATER
The Scout has been approved for use in fresh water.
▪ Use caution when walking on wet surfaces.
▪ After the foot encounters moisture, wipe it dry using a lint-free cloth.
WARNINGS
WARNING
Do not expose this product to corrosive materials, salt water or pH extremes.
▪
Any further disassembly or modification of components will void the warranty.
▪
Failure to follow these technical instructions or use of this product outside the scope of its Limited Warranty may result in
injury to the patient or damage to the product.
RESIDUAL RISK STATEMENT
NOTICE OF RESIDUAL RISK
During fitting process, ensure that CPI sock does not become pinched between foot and
▪
endoskeletal componentry.
WARRANTY INSPECTION AND MAINTENENCE INFORMATION
College Park recommends that you schedule your patients for check-ups per the warranty inspection schedule below.
High patient weight and/or impact level may require more frequent inspections. Soft component wear
depends on the patient weight, impact level and environment. We recommend you inspect the following
applicable parts for excessive wear and fatigue at each warranty inspection and replace as needed.
Composites and Adapters
▪
▪
CPI Sock
WARRANTY INSPECTION SCHEDULE FOR THE SCOUT: SIX MONTHS, THEN ANNUALLY.
TECHNICAL ASSISTANCE / EMERGENCY SERVICE 24-7-365
College Park's regular office hours are Monday through Friday, 8:30 am – 5:30 pm (EST). After hours, an emergency Technical
Service number is available to contact a College Park representative
LIABILITY
The manufacturer is not liable for damage caused by component combinations that were not authorized by the manufacturer.
CAUTION
College Park products and components are designed and tested according to the applicable official standards or an in-house defined
standard when no official standard applies. Compatibility and compliance with these standards are achieved only when College Park
products are used with other recommended College Park components. This product has been designed and tested based on single patient
usage. This device should NOT be used by multiple patients.
CAUTION
If any problems occur with the use of this product, immediately contact your medical professional. The prosthetist and/or patient should
report any serious incident* that has occurred in relation to the device to College Park Industries, Inc. and the competent authority of the
Member State in which the prosthetist and/or patient is established.
*'Serious incident' is defined as any incident that directly or indirectly led, may have led, or might lead to any of the following; (a) the death of a
patient, user, or other person, (b) the temporary or permanent serious deterioration of a patient's, user's, or other person's state of health, (c) a
serious public health threat.
Plantarflex the Scout or move load line posterior
Dorsiflex the Scout or move load line anterior
Dorsiflex the Scout or move load line anterior
Plantarflex the Scout or move load line posterior
COMPONENT CHANGE
---
---
Add heel wedge
Remove heel wedge
Foot Shell
▪
▪
Heel Wedge (if applied)
EN
Werbung
Inhaltsverzeichnis
