Cancelling/Modifying A Cycle; Cycle End - hanseatic HWMB814C Gebrauchsanleitung

Cancelling/modifying a cycle

(3)
Startzeit-
vorwahl
(11)
1. Press the button (8) to cancel or modify
an active cycle.
The washing machine will switch off.
2. Press the button again to switch the
washing machine on again.
3. Use the cycle selector (2) to select any cy-
cle and then add detergent if required.
4. Start the new cycle with the
The suds will not be pumped away after
some cycle changes. To pump the suds
away after cycle change, see "Draining" on
page EN-23.

Cycle end

The appliance stops automatically as soon as
the selected cycle is finished.
3 Sek. drücken für Individuell
7 signal tones will sound and the display (5)
Zeit sparen
Ein/Aus
Extra will show E
Spülen
Vorwäsche
Start/Pause
3 Sek.
Tür Entriegelung
1. When the locking time ends, the symbol
2. Press the
3. Leave the appliance door open and pull
button (9).
4. Turn off the tap and remove the mains
If no further settings are made, the device will
automatically switch off after 15 minutes.
the spin speed, the higher the noise emissions
and the lower the residual dampness.
Washing process
nd
.
will go out.
The appliance door will be released with a
click and you can remove the laundry.
button (8) to switch the appli-
ance off.
the dispensing drawer (1) out slightly to al-
low the inside of the appliance to dry.
plug from of the wall socket.
The spin speed affects the noise emis-
sions of the appliance and the residual
dampness of the laundry. The higher
Page EN-21